Jump to content

Tunze 6105 or Vortech MP40


dachkie
 Share

Recommended Posts

  • SRC Member

Hi need some suggestions here, i have seen the MP40 in action in drato11's house and i like the high low (wavebox effect) wave effect, but i have a problem if i get the mp40

my tank is a 3 sided view tank 5ft(L) x 2.5ft(W) x 2ft(H) and the unviewable side is a full overflow so i cant put the mp40 there as the motor will touch water,

putting at the other end , i will not have enough wire to reach it, so my only choice is to put on the 5ft side blowing 2.5ft across.

the question that i have now is can i achieve that "wavebox" effect, or can tunze 6105 do the effect also? then i wont have that much of an issue on the placement, i haven really seen a 6105 in action, in fact i haven seen any controllable tunzes in action

appreciate if any1 can advise me as i getting it before xmas

Mix Reef Tank: 5ft x 2.5ft x 2ft mixed reef

Chiller: daikin 1hp compressor

Return: Red Dragon 6.5m3

Lighting: Aqua Lumen Ocean 4ft

Skimmer: Reef Octopus RO-RPS-5000-EXT w/ Bubble Blaster

CR: RM 824 /milwakee PH controller

Tunze TS24 with 7096

Tunze Osmolator

American Pinpoint PH monitor

American Pinpoint ORP Monitor with Resun Ozone

RM sulphur denitrator

RM FR 424

RM FR 624

TLF Phosban Reactor

My old tank thread

469748_10150741487628605_529506809_o_zps36d5c396.jpg

Link to comment
Share on other sites

Bro,

What is MP40 and Tunze 6105?

Are both also wavemaker?

Can post pic of both?

6.5 * 2 * 2 + 3.75 * 1.5 *1.5,(Decomn on 14/9/08)
4*2*2 + 2.5*1.25*1.25 (Decomn on 1/8/09)
5*2*2 (Fully LED light system, 140 3 watt SSC leds with 60 degree lens)(Decomm)
2.5*2*2(Fully LED Light System,96 3 watt SSC leds with 60 degree lens)(Decomm)

5*2.5*2(LED only)

Eheim return 1 * pump

1 HP Daikin compressor with cooling coil
2 Jebao OW40, 1 ecotech MP40,
1X6085 Tunze wm,

1 CURVE 7 Skimmer

  1 DIY 80 led control by Bluefish mini 

1 radion XR30W G2, 2 Radion XR15G3

Sump area lite by 5 ft T5 , 6 * SSC 3 watt red LED for refugium

1 Full spectrum E27 led light

1 CR control by bubble count

Start No Water Change since 1st Dec 2016

Add new 2.5x2x 1.5 ft 

 nLekOfpYts.jpg
[/quote]


 

Link to comment
Share on other sites

bro, mp40 has been quite successful in creating wave effect. Nevertheless, this was somehow seen in 4ft tank setup. not sure whether it will be powerful enough for 5 ft. If you are placing it at the 2.5 width....the effect may be too rapid to create turbulent. maybe you want to go iwarna to test it. For 6100 series....i think it can achieve but effect may not be that satisfactory(maybe that is the reason why they came out with wave box.....)......think is to use pulsing mode to create the wave effect....

any brother or sis here can share their experience...

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

  • SRC Member

:heh: Hi Bro, where did U buy ya MP40W Gen 2 as it has not been launched in Spore yet ? :eyebrow:

i experince some prob with the mp40W gen 2.

the magnet gen 2 is too thick and cause the inside of the mp4 to spin in circle when the pump starts.

waiting for local agent to settle this prob.

Link to comment
Share on other sites

  • SRC Member

y not juz get the wavebox?

i dun like the wavebox look , very extrusive , i dun like to see equipments , or at least as small as possible where i can hide with rocks

Mix Reef Tank: 5ft x 2.5ft x 2ft mixed reef

Chiller: daikin 1hp compressor

Return: Red Dragon 6.5m3

Lighting: Aqua Lumen Ocean 4ft

Skimmer: Reef Octopus RO-RPS-5000-EXT w/ Bubble Blaster

CR: RM 824 /milwakee PH controller

Tunze TS24 with 7096

Tunze Osmolator

American Pinpoint PH monitor

American Pinpoint ORP Monitor with Resun Ozone

RM sulphur denitrator

RM FR 424

RM FR 624

TLF Phosban Reactor

My old tank thread

469748_10150741487628605_529506809_o_zps36d5c396.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      Prata and brain for sale

    2. 0

      Hailea HS66a Chiller

    3. 0

      Selling the following Items

    4. 0

      WTG Chaeto

    5. 1

      WTS Livestock

×
×
  • Create New...