Sicklid Posted September 15, 2008 Share Posted September 15, 2008 Hi, I am planning to setup a 3x3x2.5 reef tank for my new place. Was advised that one of the newer and more efficient way to chill the tank is to use the aircon unit. ie. connect a cooling coil to the output of an aircon compressor. I like the idea as I prefer not to have a conventional chiller located in the cabinet or next to the tank with warm air blowing into the living room. Caveat of course is to diy the cooling coil. Have spoken to my air-con man, all he can do is to connect the copper tubing and the thermostat control wires from the aircon compressor to where the cabinet is. He doesn't know how to connect and setup the cooling coil. I have been searching this forum and goggling for info but have so far not found anything really useful. Just wondering if anyone here has done this or know of any aircon/aquarium experts who has the know how to do this. I believe it's a matter of connecting to a titanium/copper coil (may need to coat it with something) and setup the thermostat to a control unit to view and adjust the temperature. Any advise or contacts would be much appreciated. Thanks. Quote Link to comment Share on other sites More sharing options...
SRC Member solasido Posted May 14, 2012 SRC Member Share Posted May 14, 2012 Reviving this thread. Any bro tried such DIY? Quote Link to comment Share on other sites More sharing options...
Gouldian Posted May 15, 2012 Share Posted May 15, 2012 For me, I bought air-con compressor, temperature controller and contactor and got my Air-con contractor to do the piping and installation. But instead of an exposed drop-in coil, I chose a concealed evaporator from Resun. It is similar to the one below but mine is from Resun. Quote "Reefs, like forests, will only be protected in long term if they are appreciated" Dr. J.E.N. Veron Australian Institute of Marine Science -----------------------------------------------------------------------Member of:UEN: T08SS0098FPlease visit us here: http://www.facebook....uaristSocietySG Facebook Group: http://www.facebook....gid=34281892381 Link to comment Share on other sites More sharing options...
sherman Posted May 15, 2012 Share Posted May 15, 2012 Where to get concealed evaporator? Good idea Quote 6.5 * 2 * 2 + 3.75 * 1.5 *1.5,(Decomn on 14/9/08) 4*2*2 + 2.5*1.25*1.25 (Decomn on 1/8/09) 5*2*2 (Fully LED light system, 140 3 watt SSC leds with 60 degree lens)(Decomm) 2.5*2*2(Fully LED Light System,96 3 watt SSC leds with 60 degree lens)(Decomm) 5*2.5*2(LED only) Eheim return 1 * pump 1 HP Daikin compressor with cooling coil 2 Jebao OW40, 1 ecotech MP40, 1X6085 Tunze wm, 1 CURVE 7 Skimmer 1 DIY 80 led control by Bluefish mini 1 radion XR30W G2, 2 Radion XR15G3 Sump area lite by 5 ft T5 , 6 * SSC 3 watt red LED for refugium 1 Full spectrum E27 led light 1 CR control by bubble count Start No Water Change since 1st Dec 2016 Add new 2.5x2x 1.5 ft [/quote] Link to comment Share on other sites More sharing options...
Jameshong Posted May 15, 2012 Share Posted May 15, 2012 Interested to know to......o ! Quote Knowing is not enough; we must apply. Willing is not enough; we must do. - Goethe Link to comment Share on other sites More sharing options...
xaine Posted May 15, 2012 Share Posted May 15, 2012 What's the pump capacity for this unit ? within your return pump flowrate ? If additional pump needs to drive this, then addition heat might be added. Quote FOWLR Tank : 48"x24"x30" Sump: 36"x18"x20" Return Pump : Rio 32HF Skimmer: Reef Octopus DNW-110 Lighting: 150W MH Link to comment Share on other sites More sharing options...
Gouldian Posted May 16, 2012 Share Posted May 16, 2012 Where to get concealed evaporator? Good idea Got mine from Teck Hoe, for reefers who frequent Malaysia, can get from there too, prices are very competitive there and many reefers there uses them vs Singapore. Quote "Reefs, like forests, will only be protected in long term if they are appreciated" Dr. J.E.N. Veron Australian Institute of Marine Science -----------------------------------------------------------------------Member of:UEN: T08SS0098FPlease visit us here: http://www.facebook....uaristSocietySG Facebook Group: http://www.facebook....gid=34281892381 Link to comment Share on other sites More sharing options...
Gouldian Posted May 16, 2012 Share Posted May 16, 2012 What's the pump capacity for this unit ? within your return pump flowrate ? If additional pump needs to drive this, then addition heat might be added. I use a AB2000 for pump water to the evaporator and back to sump. Quote "Reefs, like forests, will only be protected in long term if they are appreciated" Dr. J.E.N. Veron Australian Institute of Marine Science -----------------------------------------------------------------------Member of:UEN: T08SS0098FPlease visit us here: http://www.facebook....uaristSocietySG Facebook Group: http://www.facebook....gid=34281892381 Link to comment Share on other sites More sharing options...
sherman Posted May 17, 2012 Share Posted May 17, 2012 Got mine from Teck Hoe, for reefers who frequent Malaysia, can get from there too, prices are very competitive there and many reefers there uses them vs Singapore. Thank You bro for sharing the info Quote 6.5 * 2 * 2 + 3.75 * 1.5 *1.5,(Decomn on 14/9/08) 4*2*2 + 2.5*1.25*1.25 (Decomn on 1/8/09) 5*2*2 (Fully LED light system, 140 3 watt SSC leds with 60 degree lens)(Decomm) 2.5*2*2(Fully LED Light System,96 3 watt SSC leds with 60 degree lens)(Decomm) 5*2.5*2(LED only) Eheim return 1 * pump 1 HP Daikin compressor with cooling coil 2 Jebao OW40, 1 ecotech MP40, 1X6085 Tunze wm, 1 CURVE 7 Skimmer 1 DIY 80 led control by Bluefish mini 1 radion XR30W G2, 2 Radion XR15G3 Sump area lite by 5 ft T5 , 6 * SSC 3 watt red LED for refugium 1 Full spectrum E27 led light 1 CR control by bubble count Start No Water Change since 1st Dec 2016 Add new 2.5x2x 1.5 ft [/quote] Link to comment Share on other sites More sharing options...
AroDan Posted August 30, 2012 Share Posted August 30, 2012 Can any bro share a drawing on how the whole setup suppose to connect. I'm very interested to know. Can also advise an estimated cost of the whole setup. Quote Link to comment Share on other sites More sharing options...
SRC Member reefer guy Posted August 30, 2012 SRC Member Share Posted August 30, 2012 Can any bro share a drawing on how the whole setup suppose to connect. I'm very interested to know. Can also advise an estimated cost of the whole setup. this might help http://www.guarriello.net/chiller.htm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.