Jump to content

Have a look at my bubble...need advice


MbmC
 Share

Recommended Posts

  • SRC Member

My green bubble has been with me for 3 weeks.

Used to expand very nicely, but in the last 2 days, some of the bubbles in one small corner of the coral not expanding like they used to. All tentables are still extending well, even around the area that's not expanding.

Water parameters all good. Flow has not changed, but lighting has changed, with me adding 2 x 24W white lights to a total of 6 tubes.

Also noticed 2 small circular bare spots on the flesh of the bubble coral with 2 lines sticking of it, around the area that's not expanding. Are these parasites or something?

What's causing this area of the bubble to stay small? But tentables still extending nicely?

Temp 25-26

pH 8.3

kH 10.2-11.3

Ca 420

PO4 0

NH4 <0.25 (Lowest reading on Salifert)

NO3 10ppm

SG 1.025

Previously

DSC_0326.jpg

Now

DSC_0415.jpg

Thanks for your help

Link to comment
Share on other sites

Hi bro,

I agree with Rockyboy, I believe its showing tentacles and mouth due to its feeding respond - either its hungry or it sense there's food in the water column.

HTH ;)

"Reefs, like forests, will only be protected in long term if they are appreciated"
Dr. J.E.N. Veron
Australian Institute of Marine Science


-----------------------------------------------------------------------

Member of:

post-1182-0-60431600-1322062247_thumb.jp

post-2241-0-43391700-1354511230.png

UEN: T08SS0098F
Please visit us here: http://www.facebook....uaristSocietySG
Facebook Group: http://www.facebook....gid=34281892381

Link to comment
Share on other sites

  • SRC Member

So it looks healthy then? Just too much flow to that specific corner...

Yup, it extends the tentacles in response to food, even the corner which is not expanding as it used to. Strangely though, coz it lasted 3 weeks in that area...

Link to comment
Share on other sites

  • 2 weeks later...
  • SRC Member
Can it be your dosing of suppliment casing it not to open?

When I dose lazy without mixing with the tank water and dose slowly, my elegance will not open too.

My dosing slowly after mixing. Don't think that's the problem...

Link to comment
Share on other sites

  • SRC Member

Think I've figured out why. I was topping up my tank water with salt mix (newbie error)...so without my knowing, SG had crept up to 1.026. I had always assumed it was maintained at 1.024-1.025.

So I brought the SG down slowly over a day to 1.024 by diluting with DI water...and over the next 3 days, the bubbles have extended fully :D

Link to comment
Share on other sites

Think I've figured out why. I was topping up my tank water with salt mix (newbie error)...so without my knowing, SG had crept up to 1.026. I had always assumed it was maintained at 1.024-1.025.

So I brought the SG down slowly over a day to 1.024 by diluting with DI water...and over the next 3 days, the bubbles have extended fully :D

Hi bro,

You are right, too high SG will cause the polyp to receed. Thanks for sharing. ;)

"Reefs, like forests, will only be protected in long term if they are appreciated"
Dr. J.E.N. Veron
Australian Institute of Marine Science


-----------------------------------------------------------------------

Member of:

post-1182-0-60431600-1322062247_thumb.jp

post-2241-0-43391700-1354511230.png

UEN: T08SS0098F
Please visit us here: http://www.facebook....uaristSocietySG
Facebook Group: http://www.facebook....gid=34281892381

Link to comment
Share on other sites

  • 2 months later...
  • SRC Member

but i've check several sites and they recommend 1.026 for most inverterbrates,is it different for the green bubble?

mine also having problem now, the entire thing shrink to a small mass of tentacles, was worried so i drop it into my refugium and 1 small prawn a day and now opening up a little bit better, but definately nowhere as nice as last week,

parameters have not change, i always log my tests. except was having abit of a problem with the temperature, went up to 28, for a day but that was after the bubble was already acting weird. and i cant really reduce the salinity as i have an octopus sharing the same tank water

Mix Reef Tank: 5ft x 2.5ft x 2ft mixed reef

Chiller: daikin 1hp compressor

Return: Red Dragon 6.5m3

Lighting: Aqua Lumen Ocean 4ft

Skimmer: Reef Octopus RO-RPS-5000-EXT w/ Bubble Blaster

CR: RM 824 /milwakee PH controller

Tunze TS24 with 7096

Tunze Osmolator

American Pinpoint PH monitor

American Pinpoint ORP Monitor with Resun Ozone

RM sulphur denitrator

RM FR 424

RM FR 624

TLF Phosban Reactor

My old tank thread

469748_10150741487628605_529506809_o_zps36d5c396.jpg

Link to comment
Share on other sites

but i've check several sites and they recommend 1.026 for most inverterbrates,is it different for the green bubble?

mine also having problem now, the entire thing shrink to a small mass of tentacles, was worried so i drop it into my refugium and 1 small prawn a day and now opening up a little bit better, but definately nowhere as nice as last week,

parameters have not change, i always log my tests. except was having abit of a problem with the temperature, went up to 28, for a day but that was after the bubble was already acting weird. and i cant really reduce the salinity as i have an octopus sharing the same tank water

Hi bro,

Not to worry. Your bubble is doing find. Is just that when bubble is in blue light they normally open up and extent their tenticle to capture food.

Just like when the aquarium light is off in the night. Its bubble natural behaviour.

Link to comment
Share on other sites

  • SRC Member

i'm not sure if my bubble will recover, i put in for 3 days in my refugium and it bubble up but half of it seems gone, i only see tissue but no bubbles or tentacles, then i took it out to smell, no foul smell also, but got brown patches on the skeleton ,scrub that off as i read that it might cause irritation , then out it back into the main tank where the flow is slow, half of it bubble up nicely but the other half still a mass of small green tissue, dont know if it'll survive not, the rest of my lps ( octos, galaxea, tongue, ) softies ( hairy mushroom, yumas, discosomas, gsp, pipe organ, glove ) sps (acropora, hyrdopora) all doing well except this green bubble,

i really duno whats the cause for it

Mix Reef Tank: 5ft x 2.5ft x 2ft mixed reef

Chiller: daikin 1hp compressor

Return: Red Dragon 6.5m3

Lighting: Aqua Lumen Ocean 4ft

Skimmer: Reef Octopus RO-RPS-5000-EXT w/ Bubble Blaster

CR: RM 824 /milwakee PH controller

Tunze TS24 with 7096

Tunze Osmolator

American Pinpoint PH monitor

American Pinpoint ORP Monitor with Resun Ozone

RM sulphur denitrator

RM FR 424

RM FR 624

TLF Phosban Reactor

My old tank thread

469748_10150741487628605_529506809_o_zps36d5c396.jpg

Link to comment
Share on other sites

  • 2 months later...
  • SRC Member

thanks for sharing.. i have this problem also last time. not idea y..now i got it !!

ups for u !!!!

---2Ft Cube by MarineLife---2008-2009

http://w w w.absolutereef . com/forums/index.php?showtopic=12369

Skimmer: Deltec APF600 feeder by Eheim 1250

Lighting: Solite 150MH 14k

Supplement: Giesemann T5 Razor, Actinic Plus ~22k

Top-up: Tunze Osmolator Universal 3155

Return: Eheim 1260

Reactor: Skimz FR Rowaphos

---------------------------------------------------------

---1.5Ft Cube by Iwarna---2010- ???

http://www.sgreefclub.com/forum/index.php?/topic/95312-nano-15-cube/

Tank: 1.5Ft Cube,Sump with Chengai Wood Cabinate

skimmer: Reef Oct Nw110

Return: Eheim 1250

Chiller: Hailea HC150A with feeder Eheim Compact 1000

Reactor: Phosphan with Rowaphos

Lighting: MaxSpec G2 110w,DELighting T5 ATI*2,Giesemann T5 Razor ATI*2

WaveMaker: MP10 VorTech

Top Up : ATO with Tank

-------------------------Your Advice is my Success

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...