Tunze 3000.26 extension setup

[planetg]

Hi.

After assembling the 3000.26 extension for my 6000, i realise that its hold on the eurobrace is horrifyingly small. Is that the right way or am I missing something?

It looks as though it's gonna fall off anytime!

Anyone with pictures of your extension or modification to make it more stable? Appreciate it.

Cheers

[Tanzy]

It's correct. The top horizontal piece is only slightly less than an inch. Don't worry, the weight of the Stream plus the screws will hold it in place. My holders for the Streams have never dropped.

[planetg]

is it something like the picture attached? it's not my pic but from RC

i cannot seem to get the vertical piece which holds the pump flushed to the wall.

is it necessary cos i think it'll create much vibration on the glass right?

pls correct me if i'm wrong.

cheers.

[triggerfish]

correct .. mine are like this too ... initially also tot it would fall off .. but been 2 mths liao ... still ok!

[Chris]

I clip my tunze on my eurobracing without using the extension and it can still hold very well, following the instruction from the menu.

[planetg]

hi chris,

any pics? i need to see something cos i'm nuts with those complicated tunze diagrams!!!

thanx a lot.

[Tanzy]

Your holders look fine in the photo. Relax. If you tighten the screws well enough it's rock solid. I've tried yanking them off when I wanted to clean them but found it impossible without releasing the screw.

[planetg]

thanx tanzy. a little kan jiong here and by the way, it's not my pic. i will get a pic of mine when i get my digicam back tomolo.

cheers