how to set the desire foam for H & S

[andysho]

Hi i have inusmp F2001 model

may i know how to increase the foam , is it be increasing the water level

thanks

[tansh]

Full open air valve and adjust water at mid level of rising neck.Below is the pic after cleaning yesterday.

[andysho]

hmm actually how to adjust the water level ar?

[tansh]

Ajust from the pipe attach to the water outlet.

[yiling]

Hi there, sorry to borrow your thread.

Can we say that....by opening all valve to the max will give best results from the Skimmer ?

And for the air hose outlet, do u guys block most of the air ?

need some advice to have the optimal results

thanks thanks

[andysho]

hmm actually how to adjust the water level ar?

hmm you mean increase the height of the outlet pipe ar?

thanks

[tansh]

Just ture the pipe left or right to close the valve to ajust the water level.Refer the picture draw in red line but mine is a 400L insump model not sure same or not.

[andysho]

i already adjust output pipe but the foam still not very high

is it due to the water level too low? thanks

[andysho]

anyone can help thanks

[yiling]

where does your water lvl reaches ?

[yiling]

where does your water lvl reaches ?

mine has white tape over the point where the skimmer gets in contact with the aquabee.

hopes this will solve your prob

[andysho]

my water level reaches around 9 inches from below

is this too low or wat

Or Simply because my tank dun even have a single fish

so the foam take very slowly to go up?

[tansh]

my water level reaches around 9 inches from below

is this too low or wat

Or Simply because my tank dun even have a single fish

so the foam take very slowly to go up?

How long hv u run the skimmer?Mine took 2days than start to form up.