Jump to content

why is nitrate level keep increasing?


Recommended Posts

Sera kits allow you to use diluted samples to get higher readings, up to 400mg/L. But I did not do that.

It is wise to invest in good test kits and equiments, so as not to waste money upgrading time and again. I paid alot of school fees then. <_<

actually thinking of getting a aqua c remora. but i have a tought upgrading to a 4ft tank ;) so use prizm for the time being :lol:

Link to comment
Share on other sites

  • SRC Member

Take your time and map out the plans. Just a thought, why don't you just do the 4ft and save the hassle of upgrading again :)

Life is a Cruel Teacher. It punishes you first and then gives you the lesson

Link to comment
Share on other sites

  • SRC Member
my tank is 2months old. no fish, onli corals and 2x cleaner shrimp.

using DSB and refugium for my filtration.

tank condition:

ammonia=0

nitrite=<0.3

nitrate=80-100 :ph34r:

i change water every week for abt 30-40%.

it is a 2ft x2ft x2.5ft tank.

now got one coral dying, elegance.

but others seems doing well as the open up nicely.

pls help :cry::cry:

2 months? I suspect your dsb is not matured yet and unless your refugium is big enough and the macro algae are growing real fast, its probably not exporting nutrients fast enough.

Short term solutions include:

1. Water Change

2. Use of chemicals such as AZ-NO3

3. Feed less and juice up your skimmer

4. Lower your bio-load

Long term solutions

1. Wait for your dsb to mature, usually 6 months or more

2. get a denitrator

3. Upgrade skimmer

Sorry but I do not recall what skimmer you are using. Is it sufficient for your bio-load? Although chasing numbers is not a good thing, it is still advisable to keep nitrates as low as possible for the long term benefits of all residents in your tank. :peace: Several reefers like myself try our very best and we can maintain nitrates at undetectable which IMO is the best.

Comments are welcome!
Link to comment
Share on other sites

2 months? I suspect your dsb is not matured yet and unless your refugium is big enough and the macro algae are growing real fast, its probably not exporting nutrients fast enough.

my refugium is at least 2/3 of the size of my tank. and the DSB is abt 6inch deep.

how fast should the marco algea grow? any guide line or how long do i have to harvest.

Link to comment
Share on other sites

Take your time and map out the plans.  Just a thought, why don't you just do the 4ft and save the hassle of upgrading again  :)

actually just to try out on a smaller tank and see if i really into this hobby, if i really into it then i will dump in more money, and at the sometime get more experience :lol:

Link to comment
Share on other sites

  • SRC Member
my refugium is at least 2/3 of the size of my tank. and the DSB is abt 6inch deep.

how fast should the marco algea grow? any guide line or how long do i have to harvest.

The size sounds good and the depth should be ok, depending on grain size. You have to give it time to mature.

What skimmer are you using?

Comments are welcome!
Link to comment
Share on other sites

  • SRC Member

Er . . . I do not know of any fix rule of "how fast" is fast enough. Your refugium is big, relative to your tank size. I guess if it is growing macroalgae from wall to wall, totally filled up and you need to trim regularly like once a week, that would be pretty fast. My neighbour has a 4 ft sump that is growing very well and he does have to trim very regularly so I'll take his refugium as a rough guide.

As for a prizm, as long as you can get it to skim well, should be fine for your tank size, however, most people are struggling to get their prizm to perform to expectation. :(

Comments are welcome!
Link to comment
Share on other sites

my conclusion could be

1. yr tank not mature and lr got organism dying

2. yr tap water got no3

3. I am using Sera too. I notice that u have to wait for a while for the readings to be stabalise.

i think i will add one more ph and if there is any inprovement.

i do wait to let the reading estabilsh as the instruction say.

Link to comment
Share on other sites

As for a prizm, as long as you can get it to skim well, should be fine for your tank size, however, most people are struggling to get their prizm to perform to expectation. 

the prizm do produce skimmate, but not tat dark and only very little skimmer produce each day. i have not been emptying it for quite some time.

can this be the cause for the no3

Link to comment
Share on other sites

as for the algea. they grow nicely but seems slow to me as they hav not even fill up the tank yet. and i switch on the light for 24h/7day. i think hav to can the tube liao. now using i pink/white t4 pl tube. going to change to white/white 6500k tube. <_<

Link to comment
Share on other sites

  • SRC Member

I think adding an extra ph will not help reduce no3, its more commonly used against the formation of diatoms.

As for the skimmer, an efficient will remove the dissolved organics/proteins before it has a chance to decompose and fuel your NO3, hence it could be a cause.

As for the light, 5000-6500k is the best for macroalgae.

And finally, I still think your tank is young. You have to give it time before you can see your NO3 dropping. :)

Comments are welcome!
Link to comment
Share on other sites

  • SRC Member
I had the same problem as yours initially. I was using Sera nitrate test kit which gave me readings of >40 ppm. I then brought a sample of my water over to my friend's place and using his salifert kit, the reading was 25 ppm. I immediately threw away my sera kit. <_< Try getting a second reading with another kit. Subsequent water changes then brought my nitrate levels. BTW, what skimmer are you using?

funny....i tested my Sera test kit on my tank and it shows 80ppm. on tap water and sea water from LFS shows abt 5ppm....

remove the sponge filters and wool for my canister and ppm actually drops to 5 ppm using the sera test kit after 2 weeks.....everything seems consistant with the advise i've gotten so far...so not really sure if Sera test kits are really that inaccurate....

Link to comment
Share on other sites

actually i did the same test too, with my tank water and tap water.

the result for the tap water is actually 0ppm.

then my tank show the same result(high in nitrate). but it does drop after i change water. haven get the new test kit yet, will find out when i got get the new testkit from henry ;)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      格里菲斯大学申请学校Griffith毕业证成绩单信封Q/微993398773办理澳洲大学毕业证文凭留信认证留服认证教育部认证回国证明澳洲本科文凭硕士学位证毕业证Griffith University

    2. 0

      康涅狄格大学毕业证丢失UCONN毕业证成绩单Q/微993398773办理美国大学毕业证学位证留信认证留服认证教育部认证回国证明美国本科学位证硕士文凭成绩单 University of Connecticut

    3. 0

      西蒙菲莎大学未正常毕业SFU毕业证书Q/微993398773办理加拿大大学毕业证成绩单留信认证留服认证教育部认证回国证明加拿大本科文凭硕士学位证毕业证Simon Fraser University

    4. 0

      悉尼科技大学申请学校UTS毕业证成绩单信封Q/微993398773办理澳洲大学毕业证文凭留信认证留服认证教育部认证回国证明澳洲本科文凭硕士学位证毕业证University of Technology Sydney

    5. 0

      旧金山大学毕业证丢失USF毕业证成绩单Q/微993398773办理美国大学毕业证学位证留信认证留服认证教育部认证回国证明美国本科学位证硕士文凭成绩单University of San Francisco

×
×
  • Create New...