Jump to content

Picasso clown breeding journey


Law88
 Share

Recommended Posts

  • SRC Member

Dear reefers, I starting a tread to share my process and journey of breeding clown fish. Do send me your comments and feedback as I'm new to this journey as well :) 

To start of with, let me share my humble DIY setup:

It consist of a 15L tank which I've used a card board to wrap around the sides to ensure no direct lighting will penetrate into the tank which will case the fries to "headstand" and die trying to swim thru the glass. 

Inside the tank is pretty simple, it is just a airline tubing powered by a air pump. An air stone will be attached after the fires are bigger. 

Beside the tank, that's my rotifier culture which is a very important food source for the fries especially in the first 5 days after hatch. I've T-off an air line to supply air into the rotifier culture, just light bubbling will do. 

I've a table lamp light ready and will start to turn it on after 48 hours of the hatch. Defused thru a piece of cloth. 

And that's it! It's pretty simple setup and ready to go :) 

In the next section, I will share on progress so far of the egg thru hatch 

image.jpeg

image.jpeg

Link to comment
Share on other sites

  • SRC Member

Here are some picture of the progress of eggs hatching journey. 

In sequence, the first picture is the pot that clowns had laid their eggs in. To attract them into the pot was a easy task for me (perhaps I'm lucky :)). First I observe where the clown pair usually gather,  which in my case around the hammer. Then I simple placed the pot next to the hammer and within few days, they had swam into it and start spwaning inside. 

The subsequent next few pictures are taken on 4th, 6th and 8th days where you can clearly see the silvery eyes on most of the eggs. That's the sign of they will hatch that night when lights goes off. For my case, it has been consistent on the 8th days to hatch. 

Next section will share a little of what I'm preparing before the hatch night. 

image.jpeg

image.jpeg

image.jpeg

image.jpeg

 

image.jpeg

  • Like 1
Link to comment
Share on other sites

Well done and thanks for sharing. Need more sharing spirits. All the best. 

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

  • SRC Member

Thanks all for your comments and encouragements. Let me continue to share my pre work to laying/hatching of the eggs.

I've started cultivating the rotifers 3 weeks before the eggs were laid. This is to build up the volume of the rotifers to last thru at least 5 days after hatch where I will start mixing live baby brine shrimp then. To further increase the volume and to avoid using a big container, I've also cultivated the rotifers in the fry tank right after the eggs where laid. So when the small little guys hatched, right away they had food. I've did water change twice a day to ensure the fray tank parameters are in check as close as my DT.

I use the below test kit bottle to check for the density of rotifers by shining light thru the 2-5ml of "green water". You will be able to see small little white dots bouncing around which are rotifers. That's all I've done on the prep work before the hatch.

c6c10ab38ad3914dec3be55a784a9901.jpg

On day 8 before lights goes off, I used the below scoop to move the pot from DT to fry tank. Take special care not to expose the eggs to air. So I submerged the whole thing inside the DT and place the pot in the scoop with water covering the whole pot. The fry tank is now filled with about 10L of water which I've kept it low to ensure the fries don't have to swim too far to get their food. Once the pot is in the tank, I've placed the airline tubing (without air stone) inside the pot with just couple of bubbles a sec onto the eggs. This is to ensure the eggs has some movement and also getting oxygen.

It was certainly an exciting moment the next day morning to check on the fry tank. Walah, the tank was filled with baby fries. Below is a quick video of the fries on day one.

4a8d506251004c88f91a634043b04917.jpg

https://vimeo.com/176538177

That's all for now. I will continue to update as I move along :)

Sent from my iPhone using Singapore Reef Club mobile app

Link to comment
Share on other sites

  • SRC Member

Attached was day 3 of the fries. They have done well and have grown a little bigger. Thanks to the abundance of rotifers. I think the cultures within the tank had help to keep the numbers up given I've a smaller volume offline. Remember to feed the rotifers with microalgae food (the green stuff) every day to keep them going and multiple and do wc as well.

https://vimeo.com/176684991

Do note rotifers has very high metabolism and produce a lot of waste, of which a major fraction is ammonia that can quickly reach toxic levels. Hence frequent water changes is key to keep the water parameters in check.

Day 3 is when I've done the first water change of about 20%. Using a airline tubing to siphon the debris in the tank floor especially.

7873b9b019eacd93fec0284369280c19.jpg

As the fries are still very small, high tendency there will be some got siphon out. Hence use a clean container where you can later rescue these babies being siphoned out using a small little scoop. Avoid using net as they are still very delicate. I've rescued 4 fries during last wc.

That's it for day 3 updates. Below is just the setup for day 3 which I have removed the top cover and replace with tinted glass with a lamp to slowly expose them to lightings as they grow.

Next update will be on setup and prep to move the fries into live baby brine shrimp. Stay tuned.

4f7074f8e74ca5a6ac71ce499bd93547.jpg

63f7aac9354b66d05e41bc9afae19765.jpg

Sent from my iPhone using Singapore Reef Club mobile app

Link to comment
Share on other sites

  • SRC Member

Today I'm gonna share their day 5 progress. Did 20% water change as well to ensure water is in pristine condition. Had some casualties which I believe I might have not enough rotifer volume . From the video, clearly they had grow bigger.

https://vimeo.com/176821987

This is a time ready for live baby brine shrimps along with rotifers. Below is the setup which is pretty simple consist of the hatchery and eggs. I bought the hatchery from FnM and eggs from a fellow reefer. Keep the eggs refrigerated.

59473406296bc73fd6facd582769805a.jpg

fbf5a0722569d318750ea4c2f08a8064.jpg

Fill the hatchery with salt water then add 1 to 2 scoop of eggs, close the cover and that's it. All you do next is to wait. Within 24 hours the bb will be hatched and you just feed them to the tank.

Earlier someone asked about the tool I use to scoop rotifer. Here is what I've done. Take a normal tupperware and cut the base open. Then get a 50 micron mesh and use the tupperware cover to clamp it on. With that, you are ready to scoop these fellows :) Hope this helps.

36dc0d39d4c7e7f1220fa72ee80adf3f.jpg

4ce37fac9eb64cc3eaaa8c8cdb6b8378.jpg

4d23dfbb920654f0201bb40aabe84e14.jpg

Next update will be on fries going thru metamorphosis. Stay tuned.

Sent from my iPhone using Singapore Reef Club mobile app

Link to comment
Share on other sites

  • SRC Member

This is a quick video of the baby brine shrimp hatched. This hatchery works great with no hustle. Simply just lift up the white netting and dip into the tank.

https://vimeo.com/176912666

Here you see the fries enjoying their new food The small little black dots are the bb.

https://vimeo.com/176912782

Sent from my iPhone using Singapore Reef Club mobile app

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share




  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      Carleton Diploma毕业证,卡尔顿大学毕业证——Q微信751558146¥加拿大,毕业证,学位证,文凭,学历认证,留学认证,教育部认证,Carleton University

    2. 0

      办理!!美国MU毕业证*成绩单@Q微信751558146马凯特大学(本科/硕士)毕业证成绩单*MU学位证书文凭各大学保录取Marquette University

    3. 0

      办理!!美国BU毕业证*成绩单@Q微信751558146贝勒大学(本科/硕士)毕业证成绩单*BU学位证书文凭各大学保录取Baylor University

    4. 0

      UWO Diploma毕业证,西安大略大学毕业证——Q微信751558146¥加拿大,毕业证,学位证,文凭,学历认证,留学认证,教育部认证,University of Western Ontario

×
×
  • Create New...