Jump to content

4 x 2 x 2 Balcony tank


markietan
 Share

Recommended Posts

  • SRC Member

Hey guys I'm back after 5 years of break from reefing! Wifey gave thumbs up forĀ  a 4 x 2 x 2 at the balcony. This thread is to share my learning experience and for you guys to provide feedback and suggestions for me too. Lots to learn from everyone! =D

Most of my equipment were sourced from this forum back in March. Very nice to meet some new and old friends and learn from their experiences. Some were bought from LFS, nice to visit these LFS again after so long. My equipment list as follow

  • 4x2x2 12 inch tank w/ 3" sump and cabinet/hood
  • Deltec 1455 Skimmer
  • Jebao DCT 8000
  • OF Hydra Stream 3
  • TLF Phosban Reactor 150
  • Kamoer KSP-F03 Dosing Pump
  • Arctica 1/5 Chiller
  • Maxspect 300W R420r
  • Jebao RW20 wavemaker

Tank was filled with Red Sea Pro salt mix and RO/DI water on 26th March. Added 2 bags of CaribSea live sand and 40lb of CaribSea dry aragonite sand, 2 big live rocks from fellow reefer and many dead rocks. Dry/wet filter sump compartment also filled up with biohome, biohouse, marinepure rocks. Used Brightwell Aquatics Microbacter 7 to help seed bacteria. Also bought Prodibio Biokit but yet to dose.

This is the resulting rockscape. Stay tuned for more updates!

ato sold, thanks for all interest.

Picture of dead rocks still avail. newspaper is straits tim

IMG_20160413_005851 (Small).jpg

Link to comment
Share on other sites

Welcome back and looks good.

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

Nice scape.

Display Tank : 36" x 20" x 20" HerbieĀ overflow box design,Ā Sump : 36" x 21" x 17", Frag Tank : 16ā€ x 20ā€ x 16ā€,Ā custom built by Tank Culture.

Lightings : Ecotech Ā Radion XR15 Pro x 2 for Main Display Tank, Inled R80 x 1 for Frag Tank.

Chiller : Dalkin 1hp compressor with build-in drop coil.

Skimmer : Skimz Octa SC205i Protein Skimmer.

FR : H2OceanĀ FMR75 Fluidised Media ReactorĀ with Hailea HX-2500 (Feeder Pump) running Rowaphos.

CR : Skimz Monzter E Series CM122 Calcium Reactor.

BPR: Marine Source Biopellet Ā Reactor with Continuum Reef Biopellet Fuel.Ā 

Main Return Pump : SICCE Syncra ADV 9.0 &Ā Jebao ACQ-10000Ā Water Pump.

Wavemaker : Jebao MOW-9 x2 for Main Display Tank & Jebao SLW-20M Ā SineĀ Wave Pump for Ā Frag Tank.

Water Top Up: AutoAqua Smart ATO Lite.

Link to comment
Share on other sites

Welcome back and hope to see your update soon

6.5 * 2 * 2 + 3.75 * 1.5 *1.5,(Decomn on 14/9/08)
4*2*2 + 2.5*1.25*1.25 (Decomn on 1/8/09)
5*2*2 (Fully LED light system, 140 3 watt SSC leds with 60 degree lens)(Decomm)
2.5*2*2(Fully LED Light System,96 3 watt SSC leds with 60 degree lens)(Decomm)

5*2.5*2(LED only)

Eheim return 1 * pump

1 HP Daikin compressor with cooling coil
2Ā Jebao OW40, 1 ecotech MP40,
1X6085 Tunze wm,

1 CURVE 7Ā Skimmer

Ā  1 DIY 80 led control by Bluefish miniĀ 

1 radion XR30W G2, 2 Radion XR15G3

Sump area lite by 5 ft T5 , 6 * SSC 3 watt red LED for refugium

1 Full spectrum E27 led light

1 CR control by bubble count

Start No Water Change since 1st Dec 2016

Add new 2.5x2x 1.5 ftĀ 

Ā nLekOfpYts.jpg
[/quote]


Ā 

Link to comment
Share on other sites

  • SRC Member

Pictures of my sump! The original owner designed it with wet/dry filter compartment, then skimmer compartment (1455 fits nicely). Then it flows into a small middle compartment and through 2 bubble trap to the left most compartment for return. I modified it for the return pump to be in the center compartment and left the left most compartment as a refugium area.

Currently the return pump splits into 2. Right side goes back into tank, left side gets split into 2 again with 2 different output diameter. The larger output goes to chiller and it dumps back into the return pump compartment. The smaller output goes into Hydra, then into FR and is dumped into the refugium compartment. Return pump is set at 50% speed on the controller. Dosing pump is currently set as ATO to figure out what is my daily evaporation rate. Haven't start dosing KH/CA/MG yet but 5l bottles are on standby. Chiller is housed in a cheap Ikea coffee table and lightning power supply is also housed outside the cabinet.

Chiller is about ~1ft from the wall for hot air to circulate out. The wavemaker power supply is also housed outside but is temporary and not mounted yet as I'm using a 12V supply. The original 24V is too strong. Am waiting for a variable power supply to arrive and will probably run at 18V.

Some future changes that I might implement. The lightning power supply runs quite hot... am thinking of adding active cooling. The right side 'compartment' fits a 80mm computer fan just nice. I might lower the lighting fixture onto the tank edge instead of the hood, meaning it is closer to the tank surface thus reducing the intensity of the lightning and lowering the power requirement. From my observation it should be safe from the surface salt spray, need to monitor further.

I'm also thinking of switching the wavemaker to the other side of the tank. The other side of the tank has overflow box and is near to the sliding door, so hardly view from that side of the tank. Might help with increasing flow in the tank without blowing the sand, need to test when new power supply is here.

I made a mistake of not rinsing the rowaphos enough before running it and i'm still skimming rusty stuff out now...

Would love to hear any feedback or suggestions on my setup. Thanks!

IMG_20160419_235058.jpg

IMG_20160419_235119.jpg

IMG_20160419_235132.jpg

Link to comment
Share on other sites

  • SRC Member
On 23/04/2016 at 8:08 AM, Darren Sim said:

Nice tank and sump! I think your return pump section is a little too low. You can still increase it. Btw where you got your kh,mg and cal?

Sent from my iPhone using Tapatalk

Ya good idea. I might increase it to just below the 2nd bubble trap on the left so that the water from the refugium will flow over. However when I off the return pump and water flows back into the tank through the return piping before siphon break, the skimmer overflows quite fast because the return pump compartment n skimmer share the same water level... Increasing the return pump water level might make it worse.

As the siphon break hole on the return piping is already quite high, would you guys suggest to lift the skimmer higher?

Link to comment
Share on other sites

  • SRC Member
7 hours ago, Darren Sim said:

Why would you want to put your return pump in the middle?

Sent from my iPhone using Tapatalk

I wanted a refugium area and the sump tank was originally designed to have a wide compartment on the left and a narrow on in the middle. Currently I have some dead rocks and a basket of coral chips in there, but in the future might use it for chaeto and frags

Link to comment
Share on other sites

  • 9 months later...
  • SRC Member

So after months of observing and learning from other reefers, trial and error and reading up on the internet. I have changed some of my setup and equipment

ā— 4x2x2 12 inch tank w/ 3" sump and cabinet/hood
ā— Deltec 1455 Skimmer
ā— Jebao DCT 8000
ā— ATI Sunpower Dimmable 8x54W
ā— TLF Phosban Reactor 150
ā— Kamoer KSP-F03 Dosing Pump
ā— Arctica 1/4 Chiller
ā— Maxspect Gyre XF130
ā— Maxspect Gyre XF230 w/ controller
ā— Lumen Aqua LED

Some photos of my sump/refugium first followed by some FTS. Feedback n comments most welcome!

052fd2e36637be36c9d3e02b8f87fb0a.jpg
5c0c7baef07b09d0249f2abeded9988c.jpg
f403e952d814140eeb3fe80a8854a8a1.jpg
37f0c1e8c7af3e18a1696e923856fce2.jpg

FTS
b7a1f819d4f475683c3d76e56583b769.jpg

Sent from my SM-G935F using Tapatalk

Link to comment
Share on other sites

  • 2 months later...
  • SRC Member

Changed the lights in the sump to a maxspect razor. Previous light can't control blue n white separately. Now running mostly blue led on reverse cycle from the tank.

d0214c1a011e2257f5c2d7b042197ca6.jpg

Also changed 2 tubes of t5 to euroquatics e5 LED blue pop. Really like it, hopefully they will last longer n save some electricity along the way.

Bought n started dosing vibrant too, am doing half the recommended dosage for dirty tank every 3 days.

Some photos n videos for sharing
FTS under bluish lighting
04b7139e9fb69053f859b4eeafe6b290.jpg

My softies corner. Guess how many weedy type of softies is growing on this rock? (Aiptasia excluded haha)
5876091d8e1ad7ad97dfccfd6ea83b25.jpg

Mushroom rocks
a470521a33c8f96404bec28f23a658da.jpg
583742ab3c13e23dd5c0664107d46f9c.jpg

Recently poisoned by these...
7c4ba6966e86e254614a77eba95b4dff.jpg

Up and coming dragon garden
b9275712a80e7a1bc76bf169fe22c5c8.jpg

Sent from my SM-G935F using Tapatalk

Link to comment
Share on other sites

  • SRC Member

The valley in between my rock work
a1f8c231821f72c82d1a1ee22cf211cd.jpg
Spot the same rainbow Monti but different coloration under different height
0c2541310e2a17aa9f7b82008ff4d06f.jpg

My clownfish (Picasso n Domino) finally seem to have paired up and host in this gorgeous golden hammer anchora under a new 'bridge' which was recently raised.
4ebedc8f9ad922984206c4ecb850b12e.jpg
1d80d56ae6475245c6842d62b345fa60.jpg

Also the rock on the right of the tank is an aquaroche rock. Bought from a reefer at a good price, looks good and has many ledges to place corals. However coraline doesn't seem to like growing on it. First time using artificial rock... It still looks artificial in the tank after 3 months.

Anyway tank just passed 1 year old! Reconnected with some old reefing friends, made many new ones and am loving the hobby! Also thanks to SRC for keeping the passion alive in SG. :D

Sent from my SM-G935F using Tapatalk

Link to comment
Share on other sites

  • SRC Member

Oh ya.. and does anyone know why my digitatas grow out like bonsais? Small n knobby. Doesn't really grow n stretch out. Especially the forest fire... Purple digis are still not too bad.

Also see if u can spot my utter chaos colony. They morphed into something quite unique.

Sent from my SM-G935F using Tapatalk

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

    Ā 

  • Topics

  • Latest Update

    1. 2

      Berghia Nudibranch for Sale - $30

    2. 2

      Wts used hydra52

    3. 0

      WTS Many Items! Lelong Sale

    4. 0

      Wts GIANT Green Morray Eel

×
×
  • Create New...