Jump to content

DIY overflow

saphere

By saphere,
in DIY Forum

 Share

Recommended Posts

saphere Newbie

saphere

Posted
  • Author
Posted

Currently overflow is not strong enough for my return pump. I know I can add a valve to reduce flow rate on the return pump but do not wish to do so as don't want to damage the pump.

Also, overflow flow rate tends to fluctuate up and down.

Had a few occasions when the overflow failed completely resulting in pump run dry.

Really at wits end so would much rather pay someone build a new set for me :(

Link to comment
Share on other sites
  • Sponsor
dr evil Newbie

dr evil

Posted
  • Sponsor
Posted

your down flow may not be able to cope with you return pump.

1) return pump flow is to strong

2) downflow pipe is too small

Maybe you can advise what down flow pipe you using and the return pump flow rate

Razali

Link to comment
Share on other sites
acidjc Newbie

acidjc

Posted
Posted

u need to add a control valve on the overlfow pipe to the sump, this valve is a MUST.. because there is very difficut for you to get the right flowrate IN & OUT between the overlow pipe and return pump... dont add the valve on the return pump, just 1 control valve on the overflow pipe will solve your problem

Current Tank(s) :

2 x 1 x 1 mixed reef tank

What in my mind now (future tanks)

4 x 2.5 x 1.5 low profile coral tank

3 x 2.5 x 1.5 low profile reef tank

Decommissioned Tanks :

2 ft seahorse tank back in the 1990s'

2.5 ft cube mixed reef tank in 2007 to 2008

JBJ 28g Tank . Maxspect G1 110W + 12W DIY LED . Tunze 9002 Skimmer . Vortech MP10w ES . SPS only Tank . Picasso Clown Fish (2009 to 2011)

2 x 1 x 1 puffer-fishes, box-fishes & Frog-fish tank (2015)

Link to comment
Share on other sites
saphere Newbie

saphere

Posted
  • Author
Posted

Hmm I currently do have one control valve on the overflow pipe. However, the overflow pipe flowrate does not seem fast enough for the return pump, so I leave it fully open all the time.

If I close it, it would only serve to make the situation worse?

Link to comment
Share on other sites
acidjc Newbie

acidjc

Posted
Posted

Hmm I currently do have one control valve on the overflow pipe. However, the overflow pipe flowrate does not seem fast enough for the return pump, so I leave it fully open all the time.

If I close it, it would only serve to make the situation worse?

In this case, it mean that your return pump is too high. Reason because your overflow pipe was too small in size, since you cannot change the pipe, but u can change the pump to a lower flow rate. As long as the flow is 5 time and more over turn your total tank capacity, it should b fine.

Sent from my D2533 using Tapatalk

Current Tank(s) :

2 x 1 x 1 mixed reef tank

What in my mind now (future tanks)

4 x 2.5 x 1.5 low profile coral tank

3 x 2.5 x 1.5 low profile reef tank

Decommissioned Tanks :

2 ft seahorse tank back in the 1990s'

2.5 ft cube mixed reef tank in 2007 to 2008

JBJ 28g Tank . Maxspect G1 110W + 12W DIY LED . Tunze 9002 Skimmer . Vortech MP10w ES . SPS only Tank . Picasso Clown Fish (2009 to 2011)

2 x 1 x 1 puffer-fishes, box-fishes & Frog-fish tank (2015)

Link to comment
Share on other sites
acidjc Newbie

acidjc

Posted
Posted

High flow rate or too many times turn over doesn't mean good... Too fast flow rate your sump water flow too fast, the bb cannot fully settle down and grow, sane as in your main tank.

Sent from my D2533 using Tapatalk

Current Tank(s) :

2 x 1 x 1 mixed reef tank

What in my mind now (future tanks)

4 x 2.5 x 1.5 low profile coral tank

3 x 2.5 x 1.5 low profile reef tank

Decommissioned Tanks :

2 ft seahorse tank back in the 1990s'

2.5 ft cube mixed reef tank in 2007 to 2008

JBJ 28g Tank . Maxspect G1 110W + 12W DIY LED . Tunze 9002 Skimmer . Vortech MP10w ES . SPS only Tank . Picasso Clown Fish (2009 to 2011)

2 x 1 x 1 puffer-fishes, box-fishes & Frog-fish tank (2015)

Link to comment
Share on other sites
  • SRC Member
pcw Contributor

pcw

Posted
  • SRC Member
Posted

High flow rate or too many times turn over doesn't mean good... Too fast flow rate your sump water flow too fast, the bb cannot fully settle down and grow, sane as in your main tank.

Sent from my D2533 using Tapatalk

And more expensive to run too.

Link to comment
Share on other sites
  • Sponsor
dr evil Newbie

dr evil

Posted
  • Sponsor
Posted

Return pump is a Rio 17HF - 4,600l/h

Overflow pipe internal diameter is around 32mm, external around 38mm.

To be honest, I bought this tank with the overflow piping so I'm not the one who built it.

my advise, replace a pump as your RIO 4,600L/H is too powerfull for the down flow. You should get a flow rate @ 2000-2500 max and that will able solve your "sump to go dry".

you don't need any valve for your pipings......

Link to comment
Share on other sites
CKL Newbie

CKL

Posted
Posted

Alternatively, run a 2 outlet output from your return pump, one straight to tank and another return to sump. Install a valve for the latter and adjust accordingly until smooth flow is achieved from overflow pipe, with some allowance. No need to change pump. The other output can also link to any reactors you might have.

1.5' Cube | Overflow Box | 1' Sump with filter sock and 3L bacteria king | Eheim 1000 return pump | BM 3.5 | Sunsun JVP-110 wavemaker | Full spectrum Par38
Link to comment
Share on other sites
  • SRC Member
[V]tEc Newbie

[V]tEc

Posted
  • SRC Member
Posted

Am having some issues w the DIY overflow piping on my tank. Currently at wit's end trying to solve it.

Anyone willing to help me make a new set of overflow piping? Will be willing to pay a good sum.

Do post a pic of your overflow system. Its very strange that 30mm down pipe cant handle 4600l/hr flow. I am using just a single 30mm downpipe and i an using 12k + 5k return pumps. My guess is there could be trapped air inside the downpipe which results in the slow flow.
Link to comment
Share on other sites
acidjc Newbie

acidjc

Posted
Posted

Do post a pic of your overflow system. Its very strange that 30mm down pipe cant handle 4600l/hr flow. I am using just a single 30mm downpipe and i an using 12k + 5k return pumps. My guess is there could be trapped air inside the downpipe which results in the slow flow.

Agreed, my 6ft using 10000l/h pump, the overflow pipe also 32mm, no problem,

Sent from my D2533 using Tapatalk

Current Tank(s) :

2 x 1 x 1 mixed reef tank

What in my mind now (future tanks)

4 x 2.5 x 1.5 low profile coral tank

3 x 2.5 x 1.5 low profile reef tank

Decommissioned Tanks :

2 ft seahorse tank back in the 1990s'

2.5 ft cube mixed reef tank in 2007 to 2008

JBJ 28g Tank . Maxspect G1 110W + 12W DIY LED . Tunze 9002 Skimmer . Vortech MP10w ES . SPS only Tank . Picasso Clown Fish (2009 to 2011)

2 x 1 x 1 puffer-fishes, box-fishes & Frog-fish tank (2015)

Link to comment
Share on other sites
  • SRC Member
Rxcp14 Newbie

Rxcp14

Posted
  • SRC Member
Posted

Hmmm maybe post some pictures for us to see what the issues may be? DIY overflow pipe meaning those siphon type or ? Think there are some ready made ones out there like Skimz brand overflow box which I'm using.

Fresh fishes and inverts! What's next? To the salty side of marine of course!:)

"Never to part, lest jealous heaven stole our hearts"

Link to comment
Share on other sites
CKL Newbie

CKL

Posted
Posted

For DIY overflow, not the full waterflow from pipe diameter is achieved. At best slightly more than half the diameter of pipe, definitely not fully, unless you increase the pipe size for the last section before it flow to your sump. My all thru 25mm DIY overflow cannot take the full pump capacity of an ehiem 1260.

1.5' Cube | Overflow Box | 1' Sump with filter sock and 3L bacteria king | Eheim 1000 return pump | BM 3.5 | Sunsun JVP-110 wavemaker | Full spectrum Par38
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      WTS Many Items! Lelong Sale

      Please WhatsApp me at 9173two940 Deal in the East Ecotech MP10 QD - $250 each - 2 sets Good condition - Used for 4 months and kept Maxspect Gyre XF-350 - 1 pair with controller - CN Set - $300 Very good condition - Used for 1 month, washed and kept Fauna Marin Dino X - 250ml - $25 Full - Unopened Copper Power - 4 ounce - $15 Full - Unopened NeoPhos - 500ml - $15 Full - Unopened Red Slime Remover - 20g - $20 Full - Unopened Blue Life Rapid Fish Quarantine Dip - 10 pouches - $20 for all Orcalabs Phospha-Guard BIO-Cubes - 1000ml - $50 Full - Unopened Orcalabs Nitra-Guard BIO-Cubes - 1000ml - $10 Half used Ecotech RMS Mounting Bracket (Slide) for XR30 size - $20 for 2 pieces Some minor cosmetic scratches Tropic Marin Elimi-Phos Rapid - 500ml - $30 Full - Unopened Orcalabs Kalk Plus - 500g - $20 for 2 pieces Full - Unopened Brightwell SpongExcel - 4 oz - $15 Full - Unopened Popbloom 30W Refugium Light with Stand and Remote - $30 Barely used Hailea HK500A Chiller - 1 Set - $250 Good condition - Flushed Brightwell NeoNitro - 500ml - $10 Full - Unopened AquaForest Life Bio Fil - 5000ml - $60 Full - Unopened Fauna Marin Skim Breeze Reactor 1L - $40 Barely used Aqua Illumination Orbit 2 - $290 Brand new, threw away box but never used SeaTorch MS3500 Magnetic Stirrer - $30 Abit of rust residue on the plate but otherwise fully working and rarely used Neptune Apex FS-50 Flow Meter - $35 No packaging but never used before BRS Co2 Scrubber - $15 Good condition Dazs Auto Feeder - $10 Brand new Seneye Reef with Web Server - $50 Used for a year and kept. No slides. Hanna pHep+ pH Tester - $50 Rarely used - Comes with calibration fluids Hanna Salinity Tester - $80 Rarely used - Comes with calibration fluids
      Vaximus in Sell off/Pasar Malam Shop
    2. 3

      letting go softies

      im keen in the paly
      bubblefish000 in Sell off/Pasar Malam Shop
    3. 0

      Wts GIANT Green Morray Eel

      Hi selling this beautiful piece due to moving house soon pm me if keen thanks
      PowderTang in Sell off/Pasar Malam Shop
    4. 0

      WTS beginner SPS

      Monti Setosa Birdnest All for $15 Collection at west Sent from my iPhone using Tapatalk
      tansk in Sell off/Pasar Malam Shop
    5. 0

      Hailea HK-150A chiller

      Selling HK-150A chiller for $150 RFS is I just upgraded my chiller. If you're interested pls pm or contact me at 84812411
      Welly in Sell off/Pasar Malam Shop
×
×
  • Create New...