CHILLER SETTING

[anglefish]

I JUS BOUGHT A RESUN CHILLER,I HAVE A FEW DOUBT TO CHECK ...THOSE WHO HAVE THIS MODEL CHILLER...

HOW TO U DO SET TING ON THE CHILLER TEMP ?

EG: IF I TO SET IT 26C...AND CAL AT 0. SO DOES THAT MEANT ONCE THE TEMP RAISE TO 27C ,THE COMPRESSOR WILL TURN ON TILL IT DROP TO 26.(AT THIS STAGE THE CHILLER WILL BE TURN ON/OFF EVERY ABOUT 25 MINS FOR 5-7MINS ON AND OFFF AGAIN ,IF THAT OK OR CORRECT?)

2) THE CHILLER DO HAVE A "CAL SETTING"...DO U SET THAT TOO? IF YES THEN HOW SHALL I SET IT ? + OR - IT? WAT IS THE DIFFERENT BETWEEN + AND - SETTING ?

3) HOW TO DO A CORRECT SETTING FOR A CHILLER AND DO CHILLER NEED TO TURN BE ON AND OFF EVERY 30MIN IS THAT OK?THE COMPRESSOR ONLY ON FOR ABOUT >10MINS IS THAT OK AND NORMAL?

THANKS

[terryansimon]

wah don't type in caps lock leh. not good netiquette

[xiggie]

press set once and set to desired temperature example 26degree

press set and hold will get u to cal .. which is used to calibrate the temperature the chiller reads to the actual temperature of your tank water . u need a thermometer in your tank to do this ... set by increasing or decreasing to match .

the chiller has a 2 degree difference meaning it will switch on when temperature is 2degree higher then the set temperature .