Osram E-Ballast

[Kenji80]

Hi all,

Need help on Osram E-Ballast meant to light up 2 tubes. Can the Dual Osram E-Ballast be use to light up only one tube?

Thanks.

[Kenji80]

Nobody knows?

[KingFish]

Sure it can

Just use the slots you need.

[boxfish]

reply from Kisptrading is YES.

[roidan]

u may have to see the wiring on the ballast diagram...

some dual tube ballast loop one end of the tube to end of another tube...so if you leave 1 tube empty, the whole circuit in a way is broken....

not sure about that...but you gotta see the diagram printed on the osram ballast...

[boxfish]

correct, without the other tube, one tube cannot light up...tested.

unfortunately the one selling cannot provide helpful info...

hope Osram can reply me soon...

[orgasbt]

i dont think it's possible to fire up your dbl e-ballast using just one light> unless u know how to do a looping. If i am not wrong, there's 7 slots for you to insert your wires. If you dont know how to do the looping then it's not possible to fire up just one light.

Pls correct me uif i am wrong.

Thanks

[boxfish]

i dont think it's possible to fire up your dbl e-ballast using just one light> unless u know how to do a looping. If i am not wrong, there's 7 slots for you to insert your wires. If you dont know how to do the looping then it's not possible to fire up just one light.

Pls correct me uif i am wrong.

Thanks

eg if I want to use tube 1 (pin 1,2 & 3) only, should I connect the remaining point of the end cap to pin4?

or I use pin 1,2 & 5,6??

need to take a risk if no reply from expert or OSram... sigh

double

[yus75]

Thanks

eg if I want to use tube 1 (pin 1,2 & 3) only, should I connect the remaining point of the end cap to pin4?

or I use pin 1,2 & 5,6??

need to take a risk if no reply from expert or OSram... sigh

[PornStar]

I've asked the guys at Sinter before.

They told me that it was not possible to fire up one tube using a dual tube ballast.

I asked them twice on 2 separate occasions.

[boxfish]

eg if I want to use tube 1 (pin 1,2 & 3) only, should I connect the remaining point of the end cap to pin4?

or I use pin 1,2 & 5,6??

need to take a risk if no reply from expert or OSram... sigh

helo boxfish....i have another brand same wiring diagram like urs.... i connect pin 1 2 3 4only.....mine can lite up.....but dunno urs...mayb u can give a try.....but anyting happen dun blame me ya ...try at ur own risk

[anzai]

u guys talking abt mh or pl?

sorry suaku

if pl then can use 1 dual ballast to light up one tube

if mh den i dunno liao