Jump to content

calcium deposit and vinegar


kksg2000
 Share

Recommended Posts

I use about 200ml of vinegar for 10l of water, soak for 2-3 days and remove from scrubbing.

"Reefs, like forests, will only be protected in long term if they are appreciated"
Dr. J.E.N. Veron
Australian Institute of Marine Science


-----------------------------------------------------------------------

Member of:

post-1182-0-60431600-1322062247_thumb.jp

post-2241-0-43391700-1354511230.png

UEN: T08SS0098F
Please visit us here: http://www.facebook....uaristSocietySG
Facebook Group: http://www.facebook....gid=34281892381

Link to comment
Share on other sites

how long should i leave the pump running in water/vinegar mix to remove calcium deposit? and what is the ratio to mix vinegar and water?

tks.

I didn't mix with water. Soak the pump with vinegar in pail. Overnight, remove the pump rinse with water. You will observe most Ca deposit will hv gone or detach..

Get 5 liter bottle cheaper ~4 gold coin..

You can recycle used vinegar. Using filter bag and funnel to remove the dirts & residual. I kept mine more than 2 years.

Cheers and Happy Reefing..

30ikthj.gif30ikthj.gif30ikthj.gif
BANNER.jpg
1-3.jpg


LFS Map in singapore
__________________
><((((º>`·.¸¸.·´¯`·.¸.·´¯`·...¸><((((º>
·´¯`·.¸. , . .·´¯`·.. >((((º>
Cheers and Happy Reefing....

Link to comment
Share on other sites

I used the commercial packing of Heinz - buy from my friend who owns a restaurant. Vinegar is commonly used to wash and disinfect kitchen.

"Reefs, like forests, will only be protected in long term if they are appreciated"
Dr. J.E.N. Veron
Australian Institute of Marine Science


-----------------------------------------------------------------------

Member of:

post-1182-0-60431600-1322062247_thumb.jp

post-2241-0-43391700-1354511230.png

UEN: T08SS0098F
Please visit us here: http://www.facebook....uaristSocietySG
Facebook Group: http://www.facebook....gid=34281892381

Link to comment
Share on other sites

  • 2 weeks later...
  • SRC Member
how long should i leave the pump running in water/vinegar mix to remove calcium deposit? and what is the ratio to mix vinegar and water? tks. I didn't mix with water. Soak the pump with vinegar in pail. Overnight, remove the pump rinse with water. You will observe most Ca deposit will hv gone or detach.. Get 5 liter bottle cheaper ~4 gold coin.. You can recycle used vinegar. Using filter bag and funnel to remove the dirts & residual. I kept mine more than 2 years. Cheers and Happy Reefing..
Where u bought these 5litre vinegar bottle? Sent from my Android using Tapatalk2
Link to comment
Share on other sites

  • SRC Member
Just curious..what type of vinegar you guys normally use Sent from my Android using Tapatalk2 Artificial venigar. Acid with water only.
Sent from my Android using Tapatalk2 I have use these before but doesnt seem to really work.maybe I dilute with water thats why...
Link to comment
Share on other sites

  • SRC Member

To clean more thoroughly. Some calcium deposit bond some part of the equipment together, unable to open cover to clean. It could build up inside moving/ rotating parts also, causing failure or efficiency to drop over time. Some juz dun like & wanted to clean very cleaned. Some re sharp & injure u.

Sent from my GT-I9100 using Tapatalk 2

Link to comment
Share on other sites

  • SRC Member

Anyone check what's the ph of the vinegar??

ph of vinegar is ard 2-3 ,anyway i soak the Ph probe for few min then rinse it with Di water and after that recalibrate.

not sure if this ok or will spoilt the Ph probe,anyone?

Too many hobby......too little money!

Link to comment
Share on other sites

  • 4 weeks later...

ph of vinegar is ard 2-3 ,anyway i soak the Ph probe for few min then rinse it with Di water and after that recalibrate.

not sure if this ok or will spoilt the Ph probe,anyone?

You meant that after you use it in vinegar, the probe will be out of cal??

Link to comment
Share on other sites

  • SRC Member

You meant that after you use it in vinegar, the probe will be out of cal??

er...not really,if after the vinegar u wash with water and put back the reading will go back the same.

it just that b4 i do the probe carlibration i will soak it alitle while lor:)

Too many hobby......too little money!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      Selling corals Zoas

    2. 1

      Coral Decom Sale

    3. 0

      WTS: Yellow oxide Zoa

    4. 1

      Coral Decom Sale

×
×
  • Create New...