Jump to content

DIY T5 / LED light Aluminum Frame


spkentchai
 Share

Recommended Posts

  • SRC Member

Haha...wanted to integrate my T5 with Maxspect LED into a single system.....

Did a bit of research on Forum and happened to see Iceman Thread on Aluminum Frame.....cannot tahan....lunch time went down to King George Ave to get necessary stuff.

End up spent about 180+ on the basic raw materials....hopefully tonight can start a bit of the "electric sawing" n fixing..... :yahoo: :yahoo:

-
5x1.5x2ft Tank


5x2.5x2 Full Height Tank

Link to comment
Share on other sites

Lol. Remember to wear goggles and wear gloves. Lol.

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

  • SRC Member

Need to apply for Hotwork permit also....lol

haha i believe you got the joints for it also which dont need any welding...

i build my frame using "L" frame ... cheaper ...

  • Like 1

Selling big game fishing equipment. Stella 20k / 17k .. made in Japan jigging blue rose / kabuzu popping rod... pm for prices

Link to comment
Share on other sites

  • SRC Member

haha i believe you got the joints for it also which dont need any welding...

i build my frame using "L" frame ... cheaper ...

You are right bro Sunny....quite expensive to use this frame....but fixing up is quite easy except have to saw the smaller piece cos the shop do not cut if the length is less than 1.2m......tough job....picture coming up

-
5x1.5x2ft Tank


5x2.5x2 Full Height Tank

Link to comment
Share on other sites

  • SRC Member

1st frame is completed...started to assemble and sawing at 10pm....finished at 2am....lol

But not too satisfied with the outlook....will modified again to make the rack look slimmer...stay tuned.

post-21276-1334198253132_thumb.jpg

-
5x1.5x2ft Tank


5x2.5x2 Full Height Tank

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...