sherman

Wow another big project I almost miss.

You can get from Madpetz or Aquamarin

After DI you do not need them .

If you can spare time dose carbon will bring NO3 under control. You going for ulns? Zero is no good for both PO4 and NO3 unless you doing ulns

I dismiss the RO part because I do not know where to use the waste water I replace resin when tdo is 2 to 3 Usually around 3 months I do 4 salt pail wc weekly

That is about the max you can have. We have farm in Pasir Ris and Lim Chu Kang. Many Sifu here. Just drop your question here or read those threads already in the forum Happy Reefing

Wow get from where

80 deg the light penetration is about 6 ft. You need a very high tank to make use of the light. Or you hang your hydra very high

If budget allow I will go for Ecotech G4 Pro or Triton Lani Pro or Hydra 26 /52 HD

Very easy. I can help you along. What is your need?

Some software in phone has. U can get those orange cellophane paper from bookshop or art stall or you can get orange camera filter from internet like ebay,Q0010, taobao.....

Happy Reefing

Sure. In fact with the above guide any one with proper tools and right knowledge and some spare time and interest should be able to do the modification.And if you really need help or guidance I am always around.You can ask in this thread.You can PM me You can email me.(sangms1959@hotmail.com)You can whapps me(90670590)

6 tubes with 8 led arrays

4 tubes with 4 led arrays

4 tubes with led

4 tubes with led

4 tubes with led

The whole modification process is complete. Now let see some of the modification by reefers

Step 10 : Slide the Sunpower wiring into Sunpower housing wire hole. Connect the Sunpower wiring to the correct terminals. Each wire is numbered and will connect to the same numbered terminal. Wires 5/6 connect the fan like so. Wire 5 – Positive Wire 6 – Negative If the fans do not fire reverse above. I have seen it both ways. Step 11: Slide the chassis back in to housing and attach the torx/star screws back. Leave the end cap that has the controller on its side open until you connect/finish. Step 12 : The external black box will open. You will need to loosen the terminals connected to the number 3 , 4 and green wire. Take the AC cord connected to this out and connect the supplied cord like so. · Red wire – Wire 3· Black wire – Wire 4Close the box. Step 13 : Connect to the controller using the Bluefish app. Follow this video link. Once connected attach the Sunpower end cap. http://www.nanoboxreef.com/videos.html Enjoy! If you have any questions please email me. david@nanoboxreef.com or PM me Sherman

Step 9 :Connect the fan wiring to the terminals for the fans. The wiring on the Sunpower will be Red/Grey ( Positive/Negative ) or Brown/Grey ( Positive/Negative ). Connect the red wire to the positive and the black wire to the negative

I finally back with me sharing. Grouping LED into channel

Sis, U sure you want 2.5 ft height? You hair and armpit will get wet when you drop you fraq ? I have change from 2.5 ft height to 2 ft . Best is 1.5 ft

If you know a bit of electrical or electronic DIY the light it may be cheaper