typrobin

oi!!!! pics leh....dun keep me in suspense...i am refreshing my page every 20secs....hhahahaha

i think if we use the pump as a circulating pump then the problem will be solved...use another pump as a fed-pump....

i really doubt that it will safe electricity without underdriving it....150W is required to burn the MH bulb...if the E-ballast emits 140W and safe 10W...then the bulb will not be running efficiently...

yup...my place (woodlands) too...maybe some fire in sumatra or indo again??

get those kind of shiny stainless steel sheet....dr evil should be able to help u...

i think the fact that it saves electricity and that it helps lenghten bulb lifespend is only hear-say...dun really think it is proven....

oic.....

use epoxy putty....it cures underwater and i dun think it is toxic...a lot of reefers use that too...

as above?? boss, would u like to enlighten??

y not juz get a union ball valve...when u are changing water, shut the valve loh... anyway, wat i heard is that ball valve only reduces the back flow...it doesn't completely shut it down...

YEAH!!!

yup...i think so...md55 flowrate is about 3600ltr...sqwd needs about 2000ltr to operate properly, so shouldn't be a prob...

i take!!! i can even meet now!!! gimme a call...robin here....90024001

bro, dun lie lah...dun think u can do that for even 1mth, say less about 3mths...hahahaha

yup eric, i feel so too...i think if i were to seperate the 2 injectors and run individually, it should run better...not tested yet...but feel that it should... thanks for the encouragements....hope tat i will be able to post some pics of it running tomolo...

i think how many and how big, depends on your preferance...

it took hermit and i a total of 3-4 days to complete the skimmer....but around 2weeks to source for the cheapest material and equiptments....most of the acrylic are laser-cut,except for the box at the bottom which i got cut and delivered by dama... used chloroform and acrifix (as recommended by chipson) to seal up all the joints.. i must admit, even though the pic shows that it is quite nice, my workmanship is way below commercial standards...chloroform and acrifix are not that easy to handle...but it is the fun of DIYing that counts.... cross my fingers and pray that it will work...gonna run it at a close friend's place and compete with one of the best skimmers around... lotsa thanks to hermit who faithfully wake me up every morning and help me through the whole process!!! here's another look.. PS: Dr EVIL!!! show us yours!!!

Just did a water tightness test....hai....rubber gasket not doing well...gotta make some amendments....

Hi folks, just completed my RobSKim Master!!! Here's the specs: total height: 80cm 6inches reaction chamber: 40cm riser neck: 20cm footprint: 300cm X 220cm pump requirement: md55 total cost: much cheaper than i expected

one of the partners owns a 8ft tank..i've seen the tank before....OMG!!! TERRIFIC....these pple are not out to con other's money,they are experienced hobbyists prior to this business...

whao...that's damn gross...i was attacked by nudi once too...headache man...gave up and threw both pieces away, left the tank without buttons for 2mths, now i have a small piece of button but no nudi...good luck bro.... BTW, nice pic quality....

whao....he is a fat ######!!!

thumbs up for vinoth's tank...

hhhmmm...tok bout similarity...

shit....hai....gotta change plan again....